qa/qc bop maintenace submission form

    ​weekly or post well

    Testing

    Pressure test and operate the preventer every 14 days (You may be able to skip the pressure test before drilling out casing if the BOP stack was not removed, the pressure requirements for the next section are not greater than the previous test, and the time between tests has not exceeded 14 days or 30 days for blind shear rams).
    ​

    Body & bonnet

    Clean the BOP body, bonnet, and rams; remove all traces of well fluids. (weekly or after each well)
    ​

    seals/ threads

    Visually inspect all seal areas, threads, and seals; ensure no debris or damage. (do not use wire brush on sealing areas use 600-800 grit sandpaper)

    hydraulic system

    ​Check for hydraulic leaks at hoses and manifolds; verify accumulator pressure is within range.

    lubrication

    ​Grease and assemble in accordance with the Cameron Technical Manual.

    function testing

    full seal replacement testing / qa/qc

    ​I hereby acknowledge that the information, data, and technical details submitted herein are accurate and true to the best of my knowledge and belief. I affirm that all statements provided have been prepared with due diligence, and any assumptions or interpretations have been made in good faith based on the information available at the time of submission.